无氟防水剂 HOLPOSON® ECORING
HOLPOSON® ECORING是不含有氟系的单防整理剂，该系列产品符合REACH法规、OEKO-TEX Standard 100 等标准。目前国际知名品牌NIKE、ADIDAS、UNIQLO等服装公司共同参与制定危险化学品零排放（ZDHC）路线图，主要目标全面要求停止使用 C8、C6、C4等含氟（PFCs）防水防油剂。HOLPOSON® ECORING 是新理念的功能性纺织品整理剂，单独作为非氟防水剂使用，在棉纤维、合成纤维纺织品上具有优良的防水及耐水洗效果。防水耐水洗性更优异且对织物色光几乎无影响，手感也会更柔软。
无氟防水剂 HOLPOSON® ECORING
物化性能
外 观： 乳白液体
化学组成： 改性树脂水溶液
离 子： 性 阳离子
pH a值 ：3.5-4.5
溶 解 性 ：易溶于水
使用方法
1、纯棉织物
HOLPOSON® ECORING 使用浓度因加工纤维、要求性能、加工条件等而异， 为了获得耐久性的防水及防水性污渍的效果，我们推荐使用：
HOLPOSON® ECORING：60 - 80 g/L
HOLPOSON®HFM：10~20g/L
调节pH：4.5~5
干燥（带液率 70%）：120℃×90秒
焙烘：160℃×60~90秒
2 、涂层前防透浆预处理
HOLPOSON®ECORING：20-50g/L
HOLPOSON®SO：1g/L
调节pH：4.5~5
烘干120℃×90秒，适当焙烘后做涂层处理
3、涤/棉织物（65/35）耐久防水防油整理
HOLPOSON®ECORING：20～25g/L
HOLPOSON®6C：30～50g/L
HOLPOSON®HFM：15～20 g/L
HOLPOSON®SO：3～5 g/L
HOLPOSON®SOFT：8～10 g/L
pH：4.5~5
加工条件 浸轧 一浸一轧 轧余率：涤/棉65%
干燥 120℃×90秒，焙烘 160℃×60~90秒
产品性能
1. 推荐用于棉纤维、合成纤维的耐久防水、防虹吸、耐静水压整理。
2. 几乎不影响加工织物的手感和透气性，特别适合于水性涂层前的防透浆处理。
3.用于纤维素纤维时，需配合交联剂使用，即可达到优异的耐久防水效果。
注意事项
1． 使用前通过搅拌慢慢加入HOLPOSON®ECORING 到软水中 ，工作液切记不要高速搅拌，这是由于高剪切力可能会破坏乳液。
2.在做防水整理之前，请检查织物表面的残留助剂、盐、纤维等物质，这些物质的存在会会降低防水效果，因此待处理织物必须进行充分预处理，以确保没有表面活性物质残留。
3.不要一次性配制过多的工作液长时间存放，配制的工作液应尽快用完
贮 存
60kg 塑料桶包装，贮存在 0℃以上的仓库中，稳定期储存一年。开包使用后应确保容器密闭。室内存放，避免高温、严寒。
无氟防水剂 HOLPOSON® ECORING吊牌
Fluorine-Free Finishing Agent
HOLPOSON® ECORING
ECORING is a kind of water-resistant finishing agent which does not contain fluorine. This series of products comply with REACH, OEKO-TEX 100 and other standards. At present, internationally well-known brands such as Nike, Adidas, UNIQLO and other clothing companies have jointly participated in the development of a road map for Zero Discharge of Hazardous Chemicals (ZDHC), with the main goal being comprehensively discontinuing the use of C8, C6, C4 and other fluorine-containing (PFCs) waterproof and oil-repellent agents. ECORING is a new functional textile finishing agent. When used as a non fluorine waterproof agent alone, it has excellent waterproof and wash durable effect on cotton fiber and synthetic fiber textiles. The waterproof and wash durable properties are better and have little influence on the fabric color, and the hand feel will be softer.
Usage
1. Pure cotton fabric
The concentration of ECORING varies with the processing fiber, required performance, processing conditions, etc. In order to obtain durable waterproof and waterproof stains, we recommend the following:
ECORING: 60-80g/L
HFM: 10-20g/L
pH adjustment: 4.5-5
Drying (Liquid rate: 70%) at 120 ℃× 90 seconds, baking at 160 ℃× 60-90 seconds
2. Pretreatment of anti-penetration before coating
ECORING: 20-50g/L
SO: 1g/L
pH: 4.5-5
Drying for 120 ℃× 90 seconds, and make coating after proper baking
3. Durable waterproof and oil-proof finishing of polyester/cotton fabric (65/35)
ECORING: 20-25g/L
6C: 30-50g/L
HFM: 15～20 g/L
SO: 3-5g/L
SOFT: 8-10 g/L
pH: 4.5-5
Processing conditions: Padding, dip and roll once. Liquid rate: 65% (Polyester/cotton)
Drying at 120 ℃× 90 seconds, baking at 160 ℃× 60-90 seconds
Characteristics
1. It is recommended for durable waterproof, anti-siphon and hydrostatic finishing of cotton and synthetic fibers.
2. It hardly affects the hand feel and air permeability of the processed fabric, and is especially suitable for the anti-penetration treatment before the water-based coating.
3. When it is used for cellulose fiber, it needs to be used with cross-linking agent to achieve excellent durable waterproof effect.
Attentions
1. Slowly add ECORING to soft water while stirring, and do not stir at high speed. This is because the high shear force may damage the emulsion.
2. Before waterproof finishing, please check the residual auxiliaries, salts, fibers and other substances on the fabric surface. The presence of these substances will reduce the waterproof effect. Therefore, the fabric to be treated must be fully pretreated to ensure that there is no residual surfactant.
3. Do not store too much working solution for a long time, and the prepared working solution shall be used up as soon as possible.
